Order this document by MBR350/D SEMICONDUCTOR TECHNICAL DATA . . . employing the Schottky Barrier principle in a large area metal-to-silicon power diode. State-of-the-art geometry features epitaxial construction with oxide passivation and metal overlap contact. Ideally suited for use as rectifiers in low-voltage, high-frequency inverters, free wheeling diodes, and polarity protection diodes. * * * * MBR360 is a Motorola Preferred Device Extremely Low vF Low Power Loss/High Efficiency Highly Stable Oxide Passivated Junction Low Stored Charge, Majority Carrier Conduction SCHOTTKY BARRIER RECTIFIERS 3.0 AMPERES 50, 60 VOLTS Mechanical Characteristics: * Case: Epoxy, Molded * Weight: 1.1 gram (approximately) * Finish: All External Surfaces Corrosion Resistant and Terminal Leads are Readily Solderable * Lead and Mounting Surface Temperature for Soldering Purposes: 220C Max. for 10 Seconds, 1/16 from case * Shipped in plastic bags, 5,000 per bag * Available Tape and Reeled, 1500 per reel, by adding a "RL'' suffix to the part number * Polarity: Cathode indicated by Polarity Band * Marking: B350, B360 CASE 267-03 PLASTIC MAXIMUM RATINGS Rating Peak Repetitive Reverse Voltage Working Peak Reverse Voltage DC Blocking Voltage Average Rectified Forward Current, TA = 65C (RJA = 28C/W, P.C. Board Mounting, see Note 3) Non-Repetitive Peak Surge Current (2) (Surge applied at rated load conditions, half wave, single phase 60 Hz, TL = 75C) Operating and Storage Junction Temperature Range (Reverse Voltage applied) Peak Operating Junction Temperature (Forward Current applied) Symbol MBR350 MBR360 Unit VRRM VRWM VR 50 60 V IO 3.0 A IFSM 80 A TJ, Tstg *65 to 150C C TJ(pk) 150 C Symbol Max Unit RJA 28 C/W THERMAL CHARACTERISTICS Characteristic Thermal Resistance, Junction to Ambient (see Note 3, Mounting Method 3) ELECTRICAL CHARACTERISTICS (TL = 25C unless otherwise noted) (2) Characteristic Symbol Maximum Instantaneous Forward Voltage (1) (iF = 1.0 Amp) (iF = 3.0 Amp) (iF = 9.4 Amp) vF Maximum Instantaneous Reverse Current @ Rated dc Voltage (1) TL = 25C TL = 100C iR MBR350 MBR360 Unit V 0.600 0.740 1.080 mA 0.60 20 (1) Pulse Test: Pulse Width = 300 s, Duty Cycle = 2.0%. (2) Lead Temperature reference is cathode lead 1/32 from case. Preferred devices are Motorola recommended choices for future use and best overall value. Rectifier Device Data Motorola, Inc. 1999 1 20 20 10 25C 75C I , REVERSE CURRENT (mA) R TJ = 100C 10 7.0 3.0 2.0 1.0 0.50 100C 75C 0.20 0.10 0.05 *The curves shown are typical for the highest voltage device in the voltage grouping. Typical reverse current for lower voltage selections can be estimated from these same curves if VR is sufficiently below rated VR. 0.02 0.01 2.0 25C 0.005 0.002 1.0 0 80 Figure 2. Typical Reverse Current* 0.3 0.2 0.07 0.05 5.0 RATED VR Rq JA = 28C/W 4.0 dc 3.0 SQUARE WAVE 2.0 1.0 TJ = 150C F (AV) 0.03 I 0.02 0 0.2 1.0 0.4 0.6 0.8 vF, INSTANTANEOUS VOLTAGE (VOLTS) 1.2 1.4 0 0 Figure 1. Typical Forward Voltage 120 40 60 80 100 TA, AMBIENT TEMPERATURE (C) 20 140 160 Figure 3. Current Derating Ambient (Mounting method #3 per note 1) 5.0 300 4.0 200 TJ = 150C 3.0 C, CAPACITANCE (pF) P , AVERAGE POWER DISSIPATION (WATTS) F (AV) 60 0.5 0.1 SQUARE WAVE 2.0 dc TJ = 25C 100 70 50 1.0 40 0 30 0 1.0 2.0 3.0 4.0 IF (AV), AVERAGE FORWARD CURRENT (AMPS) Figure 4. Power Dissipation 2 50 20 30 40 VR REVERSE VOLTAGE (VOLTS) 10 0.7 , AVERAGE FORWARD CURRENT (AMPS) i , INSTANTANEOUS FORWARD CURRENT (AMPS) F 5.0 TJ = 150C 5.0 5.0 0 10 20 30 40 VR, REVERSE VOLTAGE (VOLTS) 50 Figure 5. Typical Capacitance Rectifier Device Data NOTE 1 -- MOUNTING DATA Data shown for thermal resistance junction-to-ambient (RJA) for the mountings shown is to be used as typical guideline values for preliminary engineering, or in case the tie point temperature cannot be measured. TYPICAL VALUES FOR RJA IN STILL AIR Mounting Method Lead Length, L (in) 1/8 1/4 1/2 3/4 RJA 1 50 51 53 55 C/W 2 58 59 61 63 C/W C/W 28 3 Mounting Method 1 P.C. Board where available copper surface is small. EEEEEEEEEEE EEEEEEEEEEE L L Mounting Method 2 Vector Push-In Terminals T-28 EEEEEEEEEEEEE EEEEEEEEEEEEE L L Mounting Method 3 EE EE EE EE EE EE EE Rectifier Device Data P.C. Board with 2-1/2 X 2-1/2 copper surface. L = 1/2'' Board Ground Plane 3 PACKAGE DIMENSIONS B NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. D 1 K DIM A B D K A INCHES MIN MAX 0.370 0.380 0.190 0.210 0.048 0.052 1.000 --- MILLIMETERS MIN MAX 9.40 9.65 4.83 5.33 1.22 1.32 25.40 --- STYLE 1: PIN 1. CATHODE 2. ANODE K 2 CASE 267-03 ISSUE C Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. "Typical" parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including "Typicals" must be validated for each customer application by customer's technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 1-303-675-2140 or 1-800-441-2447 JAPAN: Motorola Japan Ltd.; SPD, Strategic Planning Office, 141, 4-32-1 Nishi-Gotanda, Shinagawa-ku, Tokyo, Japan. 81-3-5487-8488 Customer Focus Center: 1-800-521-6274 Mfax: RMFAX0@email.sps.mot.com - TOUCHTONE 1-602-244-6609 ASIA / PACIFIC: Motorola Semiconductors H.K. Ltd.; Silicon Harbour Centre, Motorola Fax Back System - US & Canada ONLY 1-800-774-1848 2, Dai King Street, Tai Po Industrial Estate, Tai Po, N.T., Hong Kong. - http://sps.motorola.com/mfax/ 852-26668334 HOME PAGE: http://motorola.com/sps/ 4 Rectifier DeviceMBR350/D Data