ZMM 1 ... ZMM 100 ( 500mW ) Surface mount Non-Planar Silicon Zener Diodes Nicht-Planare Silizium Zener-Dioden fur die Oberflachenmontage Nominal Zener voltage Nominale Zener-Spannung 1...100 V . 5 % (E24) Standard tolerance of Zener voltage Standard-Toleranz der Zener Spannung Plastic case MiniMELF Kunststoff-Gehause MiniMELF SOD-80 DO-213AA Weight approx. - Gewicht ca. Dimensions / Mae in mm Marking: Kennzeichnung: 0.04 g Standard packaging taped and reeled Standard Lieferform gegurtet auf Rolle see page 18 siehe Seite 18 One blue ring denotes "cathode" and "Z-Diode family " The type numbers are noted only on the lable on the reel Ein blauer Ring kennzeichnet "Kathode" und "Z-Dioden-Familie " Die Typenbezeichnungen sind nur auf dem Rollenaufkleber vermerkt Maximum ratings and Characteristics Power dissipation - Verlustleistung Grenz- und Kennwerte TA = 50 /C Ptot 500mW 1) Standard Zener voltage tolerance is graded to the international E 24 standard (about 5%). Other voltage tolerances and Zener voltages on request. Die Standard-Toleranz der Zener-Spannung ist gestuft nach der internationalen Reihe E 24 (entspricht etwa 5%). Andere Toleranzen oder Zener-Spannungen auf Anfrage. Operating junction temperature - Sperrschichttemperatur Storage temperature - Lagerungstemperatur Tj TS - 50...+175/C - 50...+175/C Thermal resistance junction to ambient air Warmewiderstand Sperrschicht - umgebende Luft RthA < 170 K/W 1) Thermal resistance junction to terminal Warmewiderstand Sperrschicht - Kontaktflache RthT < 70 K/W 1 ) Mounted on P.C. board with 25 mm2 copper pads at each terminal Montage auf Leiterplatte mit 25 mm2 Kupferbelag (Lotpad) an jedem Anschlu 2 ) Tested with pulses - Gemessen mit Impulsen 3 ) The ZMM 1 is a diode operated in forward. Hence, the index of all parameters should be "F" instead of "Z". The cathode, indicated by the blue ring is to be connected to the negative pole. Die ZMM 1 ist eine in Durchla betriebene Si-Diode. Daher ist bei alle Kenn- und Grenzwerten der Index "F" anstatt "Z" zu setzten. Die durch den blauen Ring gekennzeichnete Kathode ist mit dem Minuspol zu verbinden. 15.02.2001 F:\Data\Wp\DatBlatt\Einzelblatter\zmm1..100-nicht-planar-plastik.wpd 1 ZMM 1 ... ZMM 100 ( 500mW ) Maximum ratings Grenzwerte 2 Type Typ Zener voltage ) Zener-Spanng.2) IZ = 5 mA Vzmin [V] Vzmax Dynamic resistance Inhar. diff. Widerstand rzj [S] at f = 1 kHz IZ = 5 mA IZ = 1 mA ZMM 1 3) ZMM 3.9 ZMM 4.3 ZMM 4.7 ZMM 5.1 ZMM 5.6 ZMM 6.2 ZMM 6.8 ZMM 7.5 ZMM 8.2 ZMM 9.1 ZMM 10 ZMM 11 ZMM 12 ZMM 13 ZMM 15 ZMM 16 ZMM 18 ZMM 20 ZMM 22 ZMM 24 ZMM 27 ZMM 30 ZMM 33 ZMM 36 ZMM 39 ZMM 43 ZMM 47 ZMM 51 ZMM 56 ZMM 62 ZMM 68 ZMM 75 ZMM 82 ZMM 91 ZMM 100 0.71 3.7 4.0 4.4 4.8 5.2 5.8 6.4 7.0 7.7 8.5 9.4 10.4 11.4 12.4 13.8 15.3 16.8 18.8 20.8 22.8 25.1 28 31 34 37 40 44 48 52 58 64 70 77 85 94 6.5 (<8) 80 (<95) 80 (<95) 70 (<78) 30 (<60) 10 (<40) 4.8 (<10) 4.5 (<8) 4.0 (<7) 4.5 (<7) 4.8 (<10) 5.2 (<15) 6 (<20) 7 (<20) 9 (<25) 11 (<30) 13 (<40) 18 (<50) 20 (<50) 25 (<55) 28 (<80) 30 (<80) 35 (<80) 40 (<80) 40 (<90) 50 (<90) 60 (<100) 70 (<100) 70 (<100) 70 (<100) 80 (<110) 90 (<140) 95 (<150) 100 (170) 130 (<200) 200 (<300) 0.82 4.1 4.6 5.0 5.4 6.0 6.6 7.2 7.9 8.7 9.6 10.6 11.6 12.7 14.1 15.6 17.1 19.1 21.2 23.3 25.6 28.9 32 35 38 41 46 50 54 60 66 72 79 88 96 106 Advantages of non-planar Zener-Diodes: Improved clamping capability Increased max. zener current Chips produced with EPOS-technology Molded plastic over passivated junction No glass fissures 1 - - - < 1400 < 700 < 500 < 300 < 300 < 100 < 50 < 50 < 70 < 70 < 90 < 110 < 110 < 170 < 170 < 220 < 220 < 220 < 250 < 250 < 250 < 2 50 < 300 < 700 < 750 < 750 < 300 < 700 < 750 < 750 < 750 < 800 < 800 Temp. Coeffiz. of Z-voltage ...der Z-spanng. "VZ10-4 [/C] Reverse volt. Sperrspanng. IR = 500 nA VR [V] Z-current 1) Z-Strom 1) TA = 50/C IZmax [mA] -26...-23 -7...-3 -6...-1 -5...+2 -3...+4 -2...+6 -1...+7 +2...+7 +3...+7 +4...+7 +5...+8 +5...+8 +5...+9 +6...+9 +7...+9 +7...+9 +8...+9.5 +8...+9.5 +8...+10 +8...+10 +8...+10 +8...+10 +8...+10 +8...+10 +8...+10 +10...+12 +10...+12 +10...+12 +10...+13 +10...+13 +11...+13 +11...+14 +11...+14 +11...+14 +11...+14 +11...+14 - - - - > 0.5 (1:A) > 1.0 (1:A) > 1.5 (1:A) > 2.0 (1:A) > 3.5 >6 >7 > 7.5 > 8.5 >9 > 10 > 11 > 12 > 14 > 15 > 17 > 18 > 20 > 22.5 > 25 > 27 > 29 > 32 > 35 > 38 > 40 > 43 > 48 > 52 > 62 > 63 > 70 400 122 109 100 93 83 76 69 63 57 52 47 43 39 35 32 29 26 24 21 20 17 16 14 13 12 11 10 9 8 8 7 6 6 5 5 Vorteile der flachendiffundierten Zener-Dioden: Verbesserte Impulsfestigkeit Hoherer max. Arbeitsstrom Chips hergestellt in EPOS-Technologie Passivierte Chips im Plastik-Gehause Keine Glas-Risse ) Notes see previous page - Funoten siehe vorhergehende Seite ) Mounted on P.C. board with 25 mm2 copper pads at each terminal 2 Montage auf Leiterplatte mit 25 mm2 Kupferbelag (Lotpad) an jedem Anschlu 1 ZMM 1 ... ZMM 100 (500 mW) Pulse thermal resistance vs. pulse duration 1) Impulswarmewiderst. in Abh. v.d. Impulsdauer 1) 1 ) Mounted on P.C. board with 25 mm2 copper pads at each terminal Montage auf Leiterplatte mit 25 mm2 Kupferbelag (Lotpad) an jedem Anschlu 3