TRIACISOLATED TYPE TG35F UL;E76102 M TG35F are isolated molded triacs suitable for wide range of applications like copier, microwave oven, solid state switch, motor control, light control and heater control. 7TG-F 39.2 MAX 20.2 MAX 2-4.20.1 10.8 G 20.1 MAX 21.6 MAX 30.00.1 13.9 T' 5-1.30.2 3.00.3 2.6 G 1.3 G 6.350.15 9.750.3 T1 T 7.950.15 2.0+- 0.2 T1.T2 0.0 22.5 MAX 35A High surge capability 340A Isolated NountingAC2500V Tab Terminals T1 IT AV 8.2 23.0 MAX T2 T1TAB250T=6.35, T'=8.25, t=0.8 T2TAB250T=6.35, T'=8.25, t=0.8 GTAB187T=4.75, T'=5.7, t=0.8 T2 UnitA Maximum Ratings Tj=25 unless otherwise specified Symbol Item VDRM Repetitive Peak Off-State Voltage Symbol ITRMS ITSM I2t PGM PGAV IGM VGM di/dt Tj Tstg VISO Item R.M.S. On-State Current Surge On-State Current I2t Peak Gate Power Dissipation Average Gate Power Dissipation Peak Gate Current Peak Gate Voltage Critical Rate of Rise of On-State Current Operating Junction Temperature Storage Temperature Isolation Breakdown VoltageR.M.S. Ratings TG35F40 400 Unit TG35F60 600 Conditions Tc67 One cycle, 50Hz/60Hz, peak, non-repetitive Value for one cycle of surge current IG100mA Tj25 VD12VDRM dIG/dt1A/s A.C.1 minute Mounting TorqueM4 Recommended Value 1.0-1.4 10-14 Mass Typical valueExcluding bolt, nut and wrapping material V Ratings 35 310/340 485 10 1 3 10 50 -25 to 125 -40 to 125 2500 Unit A A A2S W W A V A /s V Nm 1.515 kgfB 23 g Electrical Characteristics Symbol Item IDRM Reptitive Peak Off-State Current, max VD=VDRM, Single phase, half wave, Tj125 VTM I GT1 Peak On-State Voltage, max On-State Current2xITRMS Inst. measurement 1 Tj25IT1AVD6V 50 - I GT1 2 Tj25IT1AVD6V 50 I GT3 3 - I GT3 4 Tj25IT1AVD6V - 50 V GT1 1 Tj25IT1AVD6V 2.5 - GT1 2 Tj25IT1AVD6V 2.5 V GT3 3 - V GT3 4 Tj25IT1AVD6V - 2.5 Non-Trigger Gate Voltage, min Tj125VD12VDRM 0.2 V Turn On Time, max. ITRMSIG100mAVD12VDRMTj25dIG/dt1A/s 10 V dv/dt Critical Rate of Rise on-State Voltage,min. Tj125VD23VDRMExoponential wave. 100 V/s dv/dtc Critical Rate of Rise off-State Voltage at commutation, min Tj125VD23VDRM di/dtc15A/ms 10 V/s Holding Current, typ. Tj25 30 mA Junction to case 1.5 /W V VGD tgt IH Gate Trigger Current, max Gate Trigger Voltage, max Rthj-c Thermal Impedance, max Conditions Ratings 3 1.38 Unit mA V mA V SanRex 50 Seaview Blvd. Port Washington, NY 11050-4618 PH.(516)625-1313 FAX(516)625-8845 E-mail: semi@sanrex.com http://store.iiic.cc/ ; Gate Characteristics Peak Gate Voltage10V Av er ag e -25 25 Ga te 125 Po we r 1W Maximum Gate Voltage that will not trigger any unit - On-State Voltage Pe Po ak G we at r1 e 0W Gate Distribution On-State CurrentA Gate VoltageV Peak Gate Current3A TG35F Gate CurrentmA 180 150 120 90 2 Allowable Case Temperature Power DissipationW On State Current vs. Maximum Power Dissipation 360 F-40 Rth 2 95 Self convection F-60 Rth1.53 Self convection : Conduction Angle Surge On-State Current Rating Non-Repetitive Tj25 start 60Hz 50Hz (Rthheat Sink Thermal Impedance) Maximum Allowable Ambient Temperature Transient Thermal Impedance j-c/W F-60 3m/s Rth0.65 RMS On-State CurrentA F-40 3m/s Rth1.28 30 60 90 120 150 180 360 2 150 1.02 120 1.11 90 1.26 60 1.38 30 1.75 Conduction Angle 180 Apply following figures for different conduction angles Surge On-State CurrentA RMS On-State CurrentA Ambient temp. vs. RMS On-State Current On State Current vs. Allowable Case Temperature RMS On-State CurrentA 60 30 : Conduction Angle On-State VoltageV Timecycles Transient Thermal Impedance Self convection F-40 Self convection F-60 F-40 3m/s F-60 3m/s Junction to case Time tsec SanRex 50 Seaview Blvd. Port Washington, NY 11050-4618 PH.(516)625-1313 FAX(516)625-8845 E-mail: semi@sanrex.com http://store.iiic.cc/