3, CRIMP AND DIMENSIONAL REQUIREMENTS 3.1. Wire Preparation A. Strip Length Insulation shail be stripped as indicated in Figures 2 and 3. B. Workmanship Reasonable care shal] be taken not to nick, scrape or cut any strands or the solid wire during the stripping operation. 3.2. Wire Barrel Crimp A. Crimp Dimensions Crimp height and width shall be as shown in Figures 2 and 3. B. Wire Barre] Flash Wire barrel flash shall not exceed .008. Cc. Bellmouth Front and rear bellmouth length shail be .025 minimum. BD. Conductor Location Conductor shall be visible through the sight inspection hole, E. Workmanship Front shoulder shall not be deformed during the crimping operation. 3.3. Insulation Barrel Crimp A. Crimp Dimensions Crimp width shall be as shown in Figures 2 and 3. B. Insulation Barrel Flash Insulation barrel flash shall not exceed .010. Gc. Workmanship Reasonable care shall be taken not to cut or break the insulation during the crimping operation. Loc) SHEET | NO REV AMP INCORPORATED _ AMP Harrisburg, Pa. 17105 Bi 20F 5 Il4-i0026 0 AMP 1251-13 REV 4-62