Bench Adapter Assembly for Air-Powered Crimp Tool
Doc No: ATS-190780307 Release Date: 05-27-09 UNCONTROLLED COPY Page 2 of 3
Revision: D Revision Date: 01-09-14
Mounting the Bench Adapter
When using the bench adapter assembly, be sure the base is securely fastened to a clean, sturdy workbench or
table in a well-lighted area.
Fasten the stand with (3) #1/4-20 FHCS, nuts, and washers, not supplied, of sufficient length for the work bench.
Connecting the Crimping Tool
1. After mounting the bench adapter assembly, remove the air hose (Order No. 19279-0140) from the crimp tool
and connect the tubing from the footswitch. See Figure 1.
2. When using the optional electrical controls with the bench adapter, (Order No. 64001-4000), refer to the
operation manual Document No. TM-192790001.
3. Loosen the (2) two 3/8-16 cap screws enough to allow the crimp tool to pass through the opening in the bench
adapter. See Figure 1.
4. Slide the crimp tool head through the opening of the bench adapter until the crimp tool is approximately 1/3 to
1/2 through the bench adapter. See Figure 1.
5. Rotate the crimp tool until the trigger is beneath the air cylinder end. See Figure 1.
6. Hold the crimp tool in position and tighten the (2) two 3/8-16 cap screws evenly to secure the crimp tool. There
will be a small gap between the upper and lower halves of the bench adapter after tightening the cap screws.