101.6mm (4.0 INCH) 5x7 DOT MATRIX DISPLAY TA40-11EWA Features HIGH EFFICIENCY RED Description 4.0 INCH MATRIX HEIGHT. The High Efficiency Red source color devices are made with DOT SIZE 10mm. Gallium Arsenide Phosphide on Gallium Phosphide Orange LOW CURRENT OPERATION. Light Emitting Diode. HIGH CONTRAST AND LIGHT OUTPUT. COMPATIBLE WITH ASCII AND EBCDIC CODES. STACKABLE HORIZONTALLY. COLUMN ANODE AVAILABLE. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. MULTICOLOR AVAILABLE. MECHANICALLY RUGGED. STANDARD : GRAY FACE, WHITE DOT. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2481 REV NO: V.5 DATE: OCT/26/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI PAGE: 1 OF 4 ERP:1332000226 Selection Guide Part No. Dice TA40-11EWA Iv (ucd) @ 10mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 3000 16000 Column Anode Units Test Conditions Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. peak Peak Wavelength High Efficiency Red 627 nm IF=20mA D Dominant Wavelength High Efficiency Red 625 nm IF=20mA 1/2 Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance (Per Chip) High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage (Per Dot) High Efficiency Red 4.0 5.0 V IF=20mA IR Reverse Current (Per Dot) High Efficiency Red 10 uA VR = 10V Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation (Per Dot) 150 mW DC Forward Current (Per Dot) 30 mA Peak Forward Current [1] (Per Dot) 160 mA Reverse Voltage (Per Dot) 10 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature[2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2481 REV NO: V.5 DATE: OCT/26/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI PAGE: 2 OF 4 ERP:1332000226 High Efficiency Red TA40-11EWA SPEC NO: DSAD2481 REV NO: V.5 DATE: OCT/26/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI PAGE: 3 OF 4 ERP:1332000226 PACKING & LABEL SPECIFICATIONS TA40-11EWA Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous intensity/ luminous flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2481 REV NO: V.5 DATE: OCT/26/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI PAGE: 4 OF 4 ERP:1332000226