CLEANING 10000 Voltage [V] Impulse 100 DC + peak AC 1 10 100 1000 Frequency [MHz] SAFETY INFORMATION The probe is designed to be safe under the following conditions: Indoor use Altitude to 2000 m Temperature range from 0 C to 50 C Maximum relative humidity 80 % for temperatures up to 31 C, decreasing linearly to 40 % relative humidity at 50 C WARNING Do not disassemble or disconnect probes while they are connected to a voltage source. Use only grounded oscilloscopes. Attention: Refer to this manual before using the probe. Danger. High Voltage. PPE 4 kV USING AND MAINTENANCE 10 0,1 HIGH VOLTAGE The exterior of the probe only should be cleaned with a soft cloth moistened with either water or isopropyl alcohol. 1000 The probe user should note that the protection provided by the equipment may be impaired, if the equipment is used in a manner not specified by the manufacturer. To guarantee accurate performance characteristics, machanical shocks should be avoided, as well as damage to the cable through excessive bending. Handle with care, especially when the extra thin spring-tip is fitted. All maintenance should be referred to qualified personnel. SALES & SERVICE LECROY Corporate Headquarters U.S.A.: Chestnut Ridge Phone (1) 914 578 6020 Fax (1) 914 578 5985 European Headquarters Germany: Heidelberg Phone (49) 6221 827 00 Fax (49) 6221 834 655 ELECTRICAL CHARACTERISTICS System attenuation: 100:1 System input resistance: 50 M Input capacitance: < 6 pF Compensation range: 10 pF to 50 pF System BW (-3 dB): 400 MHz typical Max. non-destructive input voltage: 4 kV See voltage derating curve GENERAL CHARACTERISTICS Operating temperature: 0 C to 50 C Cable length: 2 m Weight of probe + accessories: 70 gr Coupling: 1 M DC/AC Warranty: One year Overvoltage category: CAT I Pollution degree: 1 LF PROBE ADJUSTMENT (100:1) HF PROBE ADJUSTMENT Connect the probe to a 1 kHz square wave signal. Adjust compensation trimmer in the BNC-box for optimum square wave response. The probe can be adjusted for high frequency if necessary. Remove boot and isolation from BNC-box. Connect the probe to 1 MHz square wave signal. Turn the PCB in the BNC-box by 180 and adjust this trimmer for optimum square wave response. Then replace all parts again in their previous position. 11 10 2 1 5 3 6 7 8 STANDARD ACCESSORIES SUPPLIED Undershoot 9 4 OPTIONAL PROBE KIT PK103 WITH THE PROBE Undershoot Correct Correct Accessories 1. Trimming tool 2. Sprung hook 3. IC Insulating tip (red) 4. Insulating tip (red) 5. Ground lead (22 cm) 6. BNC Adapter 7. Straight tip (0.8 mm) 8. Spring contact tip (0.8 mm) 9. Crocodile clip 10. Flexible 4 mm security adapter 11. Security ground lead Quantities 1 1 1 1 1 1 1 1 1 1 1 The following accessories are rated up to: Sprung hook 1000 V BNC Adapter 100 V Crocodile clip 1000 V Flexible 4 mm security adapter 1000 V Overshoot Overshoot Same as standard accessories supplied with probe, except for: Straight tip (5 pieces) Spring contact tip (5 pieces) Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Teledyne LeCroy: PPE4KV