P4SMAJ SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE - 5.0 TO 170 Volts 400Watt Peak Power Pulse
FEATURES
l For surface mounted applications in order to
optimize board space
l Low profile package
l Built-in strain relief
l Glass passivated junction
l Low inductance
l Excellent clamping capability
l Repetition Rate(duty cycle):0.01%
l Fast response time: typically less than
1.0 ps from 0 volts to BV for undirectional types
l Typical ID less than 1A above 10V
l High temperature soldering :
250/10 seconds at terminals
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
MECHANICAL DATA
Case: JEDEC DO-214AC low profile molded plastic
Terminals: Solder plated, solderable per
MIL-STD-750, Method 2026
Polarity: Indicated by cathode band except bi-directional types
Weight: 0.002 ounces, 0.064 gram
Standard packaging:12 mm tape per(EIA 481)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25ambient temperature unless otherwise specified.
SYMBOL VALUE UNITS
Peak Pulse Power Dissipation at TA=25, Fig. 1 (Note 1,2,5) PPPM Minimum 400 Watts
Peak forward Surge Current per Fig. 5 (Note 3) IFSM 40.0 Amps
Peak Pulse Current current on 10/1000s waveform
(Note 1,Fig 2) IPPM See Table 1 Amps
Steady State Power Dissipation (Note 4) PM(AV) 1.0 Watts
Operating Junction and Storage Temperature Range TJ,TSTG -55 to +150
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above TA=25per Fig. 2.
2.Mounted on 5.0mm2 copper pads to each terminal.
3.8.3ms single half sine-wave, duty cycle= 4 pulses per minutes maximum.
SMA/DO-214AC