TVS Diode Arrays (SPA(R) Diodes) Lightning Surge Protection - SP4065 SP4065 Series 3.3V 20A Diode Array RoHS Pb GREEN Description The SP4065 integrates low capacitance diodes with an additional zener diode to protect each I/O pin against ESD and high surge events. This robust device can safely absorb up to 20A per IEC 61000-4-5, 2nd Edition (tp=8/20s) without performance degradation and a minimum 30kV ESD per IEC 61000-4-2 International Standard. Their low loading capacitance also makes them ideal for protecting highspeed signal pins. Pinout Features I/O 1 I/O 8 I/O 2 I/O 7 I/O 3 I/O 6 I/O 4 I/O 5 * AEC-Q101 qualified * Halogen free, Lead-free and RoHS compliant * Moisture Sensitivity Level (MSL - Level 1) Applications I/O 6 I/O 7 * E FT, IEC 61000-4-4, 40A (5/50ns) * L ow capacitance of 4.4pF (TYP) per I/O Functional Block Diagram I/O 8 * L ow leakage current of 1A (MAX) at 3.3V * L ightning, IEC 61000-4-5, 2nd Edition 20A (8/20s) GND NC * E SD, IEC 61000-4-2, 30kV contact, 30kV air I/O 5 * LCD/LED TVs * Notebooks * Desktops * 1Gb Ethernet * Game Consoles * Network Hardware * Set Top Boxes * Small Cells Application Example LVDS Interface I/O 1 I/O 2 GND I/O 3 I/O 4 LVDS Controller CLK+ CLKA0+ Additional Information A0- Outside World A1+ A1A2+ Datasheet Resources Samples A2- Signal Shield GND SP4065-08ATG Life Support Note: Shield GND Not Intended for Use in Life Support or Life Saving Applications The products shown herein are not designed for use in life sustaining or life saving applications unless otherwise expressly indicated. (c) 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 12/29/16 TVS Diode Arrays (SPA(R) Diodes) Lightning Surge Protection - SP4065 Thermal Information Absolute Maximum Ratings Symbol Parameter Value Parameter Units Rating Units -55 to 150 C IPP Peak Current (tp=8/20s) 20.0 A Storage Temperature Range PPK Peak Pulse Power (tp=8/20s) 300 W Maximum Junction Temperature 150 C TOP Operating Temperature -40 to 125 C Maximum Lead Temperature (Soldering 20-40s) 260 C TSTOR Storage Temperature -55 to 150 C CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Electrical Characteristics (TOP=25C) Parameter Symbol Reverse Standoff Voltage VRWM Test Conditions Min Typ Max Units 3.3 V 1.0 A Snap Back Voltage VSB ISB=50mA Reverse Leakage Current ILEAK VR=3.3V, I/O to GND 0.5 IPP=1A, tp=8/20s, Fwd 5.5 V IPP=5A, tp=8/20s, Fwd 7.0 V IPP=10A, tp=8/20s, Fwd 9.0 V IPP=20A, tp=8/20s, Fwd 13.5 V (VC2 - VC1) / (IPP2 - IPP1) 0.4 Clamp Voltage1 VC Dynamic Resistance RDYN ESD Withstand Voltage1 VESD Diode Capacitance 1 Diode Capacitance 1 2.8 V IEC61000-4-2 (Contact) 30 kV IEC61000-4-2 (Air) 30 kV CI/O-GND Reverse Bias=0V 4.4 CI/O-I/O Reverse Bias=0V 2.2 5.0 pF pF Note: 1. Parameter is guaranteed by design and/or device characterization. Clamping Voltage vs. IPP Capacitance vs. Bias 14.0 5.0 12.0 Capacitance (pF) Clamp Voltage (VC) 4.0 10.0 8.0 6.0 3.0 2.0 4.0 1.0 2.0 0.0 0.0 1.0 3.0 5.0 7.0 9.0 11.0 13.0 15.0 Peak Pulse Current-IPP (A) 17.0 19.0 21.0 0 0.5 1 1.5 2 2.5 3 Bias Voltage (V) (c) 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 12/29/16 TVS Diode Arrays (SPA(R) Diodes) Lightning Surge Protection - SP4065 Product Characteristics 8/20s Pulse Waveform 110% Lead Plating Pre-Plated Frame Lead Material Copper Alloy Lead Coplanarity 0.0004 inches (0.102mm) Substrate material Silicon Body Material Molded Epoxy, rated UL 94 V-0 100% 90% Percent of IPP 80% 70% 60% 50% 40% 30% Notes : 20% 1. All dimensions are in millimeters 10% 2. Dimensions include solder plating. 0% 0.0 5.0 10.0 15.0 20.0 25.0 30.0 3. Dimensions are exclusive of mold flash & metal burr. 4. Blo is facing up for mold and facing down for trim/form, i.e. reverse trim/form. Time (s) 5. Package surface matte finish VDI 11-13. Soldering Parameters Pre Heat - Temperature Min (Ts(min)) 150C - Temperature Max (Ts(max)) 200C - Time (min to max) (ts) 60 - 180 secs Average ramp up rate (Liquidus) Temp (TL) to peak 3C/second max TS(max) to TL - Ramp-up Rate 3C/second max Reflow - Temperature (TL) (Liquidus) - Temperature (tL) 217C tP TP Pb - Free assembly Temperature Reflow Condition Critical Zone TL to TP Ramp-up TL TS(max) tL Ramp-do Ramp-down Preheat TS(min) 25 tS time to peak temperature Time 60 - 150 seconds Peak Temperature (TP) 260+0/-5 C Time within 5C of actual peak Temperature (tp) 20 - 40 seconds Ramp-down Rate 6C/second max Time 25C to peak Temperature (TP) 8 minutes Max. Do not exceed 260C Part Numbering System SP 4065 - 08 A T G G= Green TVS Diode Arrays (SPA(R) Diodes) T= Tape & Reel Package A = MSOP10 Series Number of Channels Ordering Information Part Marking System Part Number Package Marking Min. Order Qty. SP4065-08ATG MSOP-10 AAH8 4000 LF Product Series AA= SP4065 YYWWD AA*8 YYWW = Date code Number of Channels Assembly Site (c) 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 12/29/16 TVS Diode Arrays (SPA(R) Diodes) Lightning Surge Protection - SP4065 Package Dimensions -- MSOP-10 E 0.50 [0.0197] 1.04 [0.0409] 4.24 [0.1669] E1 5.28 [0.2079] 3.20 [0.1260] 10 2.00 [0.0787] D 0.32 [0.0126] Solder Pad Layout 1 2 A C Package Pins 10 JEDEC MO-187 Millimeters e A1 Inches DIM Min Max Min Max A - 1.10 - 0.043 A1 0.00 0.15 0.000 0.006 B 0.17 0.27 0.007 0.011 c 0.08 0.23 0.003 0.009 D 2.90 3.10 0.114 0.122 E 4.67 5.10 0.184 0.200 E1 2.90 3.10 0.114 0.122 0.50 BSC e L B MSOP 0.020 BSC 0.40 0.80 0.016 0.032 L Embossed Carrier Tape & Reel Specification -- MSOP-10 Millimetres Min E 1.65 Inches Max Min 1.85 0.065 0.5 e Max 0.073 0.02 F 5.40 5.60 0.213 0.220 D 1.50 1.60 0.059 0.063 1.50 Min D1 0.059 Min P0 3.90 4.10 0.154 0.161 W 11.70 12.30 0.460 0.484 P 7.90 8.10 0.311 0.319 A0 5.20 5.40 0.205 0.213 B0 3.20 3.50 0.126 0.138 K0 1.20 1.50 0.047 0.059 t 0.30 +/- 0.05 0.012+/- 0.002 Pin 1 Location User Feeding Direction (c) 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 12/29/16 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Littelfuse: SP4065-08ATG