P7 PS P3 Pl ELECTRICAL SPECIFICATIONS: NOTE: OPERATING TEMPERATURE RANGE: 40C TO +85C PINS NOT ELECTRICALLY CONNECTED ARE OMITTED, 1.0 INDUCTANCE: (P6J6) : (P1J1) : 65 uH TYP @.01V, 10KHz 2.0 DC RESISTANCE: P6J6 : .5 OHM MAX P3-J3 : .5 OHM MAX P2-J2 : .5 OHM MAX P1J1 : .5 OHM MAX 3.0 3.0 COMMON MODE: : CMA (dB) FREQUENCY <MHz) TYPICAL MIN 8 5 5 17 15 eo e3 15 70 25 20 200 22 17 Bel Stewart Connector MagJad 11118 Susquehanna Trail, South 500 11 6 Glen Rock, Pa 17327-9199 717.234.7512 hitp://www.stewartconnector.com THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON ARE CONFIDENTIAL AND PROPERTY OF BEL STEWART ONNECTOR AND SHALL NOT BE REPRODUCED, COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN CONTENT SHEET OF 3 DRAWING NO. SI-40015 ma A OF BEL STEWART CONNECTOR, THE SUBJECT MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. L .635 [16.13] MAX. | MagJack Part Number CNTRY YYWW FC Bel Stewart 850 [21.59] MAX. (.708 [17.98] J L 450 [11. ol OF (148 [3.75 HIGHEST POINT 050 [1.27] TYP +-(.599 [15.21] || (.014 [0.36]) ( .083 [2.12] ) HIGHEST POINT OF BEAM = }~.495 [10.79] f=) 025 [0.64] #.035 [0.89] +.003 [0.08] (8) 1 100 [2.54] TYP goos[ois]]} = = \ tyt_ 4 PIN Pt (SIGNAL) 1 a | _ 100 [2.54] #.062 [1.57] +.003 [0.08] (2) e TY |] @o06 [0.15]] (SHIELD) g > -<p- | 950 [6.35] ax Tt 120 [3.05] | 128 [3.25] NW L/ way tt bo o5 (2) (Posts) 160 [4.06] 125 [3.18] D+ GRN YEL | 006 [0.15] LO) J 1 | z .040 [1.02] 4.003 [0.08] (4) (LEDS) SY 2 [018] H 006 [0.15] 450 [11.43] v4 [Lon [15.26] 1 4 5 610 [15. a 6B a P.C.B. RECOMMENDED HOLE LAYOUT i SEEN FROM COMPONENT SIDE ALL CENTERLINE DIMENSIONS ARE BASIC. - .040 [1.02] NOTES: {. CONNECTOR MATERIALS: HOUSING: THERMOPLASTIC UL94 V-0 CONTACT/SHIELD: COPPER ALLOY SHIELD PLATING: NICKEL OR TIN CONTACT PLATING: SELECTIVE GOLD, 50 MICRO-INCHES MIN. IN CONTACT AREA. 2. PIN NOT ELECTRICALLY CONNECTED MAYBE OMITTED. SEE ELECTRICAL DRAWING FOR OMITTED PINS. 3. TOLERANCES COMPLY WITH F.C.C. DIMENSION REQUIREMENTS. LED SPECIFICATION > ALL TOLERANCES NOT OTHERWISE SPECIFIED TO BE +.005 [0.13] 5. WAVE SOLDER COMPATIBLE PREHEAT 125'C/90SECS. HIGH TEMPERATURE REFLOW COMPATIBLE 230C/90 SEC MAX. STANDARD LED | WAVELENGTH | FORWARD V (MAX)| #*(TYP) GREEN 565 nm 25V] 22 V YELLOW 590 nm 25V] 21 *WITH A FORWARD CURRENT OF 20 mA (TYP) OF BEL STEWART CONNECTOR, THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON ARE CONFIDENTIAL AND PROPERTY OF BEL STEWART ONNECTOR AND SHALL NOT BE REPRODUCED, COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN CONTENT| THE SUBJECT MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. Bel Stewart Connector 11118 Susquehanna Trail, South Glen Rock, Pa 17327-9199 717.234.7512 MagJack http: //www.stewartconnector.com SHEET 2 OF 3 DRAWING NO. SI-40015|""10 656 ven] >\ 554 [14.07] SUGGESTED PANEL OPENING L 00 [0.00] (TOP OF PCB TO BOTTOM OF OPENING) 010 [0.25] MAX. RADIUS(4) 2. POINT OF CONTACT WITH PANEL 080 [2.03] ==> == \ + + tb 275 [6.98] MAX. 1. THE SUGGESTED PANEL OPENING IS INTENDED TO GIVE THE USER THE ABILITY TO HAVE REASONABLE JACK / PANEL CLEARANCES YET MAINTAIN RELIABLE GROUNDING CAPABILITY. TO BE +.005 [0.13] ALL TOLERANCES NOT OTHERWISE SPECIFIED THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON ARE CONFIDENTIAL AND PROPERTY OF BEL STEWART Bel Stewart Connector 11118 Susquehanna Trail, South Glen Rock, Pa 17327-9199 717.234.7512 MagJad http://www.stewartconnector.com ONNECTOR AND SHALL NOT BE REPRODUCED, COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN CONTENT) SUEET OF BEL STEWART CONNECTOR. THE SUBJECT MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. 3 OF 3 DRAWING NO. S|4001 5 REV. 08