1
·ç»ª¸ß¿Æ
特性表SPECIFICATIONS
NP 特性 FEATURE
寿命: 85℃ 1000小时 Life time:85℃ 1000 hours
无极性 Non-polarity
适用于极性变换电路
Ideally suited for exchange polarity circuit
标称静电容量大于1000μF者,其标称静电容量每增加1000μF,损耗角正切值增加0.02
When capacitance is over 1000 tanδ shall be added 0.02 with increase of every 1000 μF
阻抗比(120Hz)
Impedance Ratio
项目Item 主要特性Performance Characteristics
额定工作电压范围
使用温度范围
标称静电容量范围
Nominal Capacitance Range 0.1μF~1000μF
静电容量允许偏差
Capacitance Tolerance ±20%(M,+20℃,120Hz)
漏电流
Leakage Current
施加额定电压2分钟:I≤0.03CV 或 5μA(取较大者)20℃
After application of rated voltage for 2 minutes: I≤0.03CV or 5μA(Whichever is greater)20℃
损耗角正切值(tanδ)
Dissipation Factor
额定工作电压(V)Rated Working Voltage
温度特性
Temperature Stability
额定工作电压(V)
Rated Working Voltage
高温负荷特性
Load Life
漏电流
Leakage current 不大于初期规定值
Less than the initial specified value
初始值的±25%以内
Within ±25% of the initial measured value
Capacitance Change
静电容量变化
损耗角正切值
Tanδ
高温贮存特性
Shelf Life
在+85℃环境中无负荷放置1000小时后,电容器的性能符合高温负荷特性中所列的规定值
After leaving capacitors under no load at +85℃ for 1000 hours, capacitors meet the
characteristics listed above
6.3V.DC-100V.DC
Operating Temperature Range
-40℃ ̄+85℃
Rated Voltage Range
C: 标称静电容量(μF); C: Nominal Capacitance in μF;
V:额定工作电压(V) V: Rated Working Voltage in V
6.3 10 16 25 35 50 63 100
tanδ(MAX)(20℃,120Hz) 0.25 0.25 0.20 0.20 0.15 0.15 0.15 0.15
6.3 10 16 25 35 50 63 100
6 4 2
12 10 3
在+85℃环境中施加工作电压和最大允许纹波电流1000X2小时后,
电容器的性能符合下表要求:
After application of rated working voltage and maximum permissible ripple current specified at +85℃
for 1000×2 hours, capacitors meet the characteristics requirements measured at +20℃ listed below
Less than 200% of the initial specified value
不大于初期规定值的200%
Freq(Hz)
Cap(μF) 50(60) 100(120) 1k 10k≤
0.1 ̄47 0.8 1.0 1.20 1.50
100 ̄1000 0.8 1.0 1.10 1.20
4
8
3
6 4
纹波倍乘因子MULTIPLIER FOR RIPPLE CURRENT
频率因子Frequency coefficient