FPIL MPIL MINIBRIDGE 40/50 AMPERE SINGLE-PHASE, FULL-WAVE BRIDGES INTEGRALLY MOLDED HEAT SINK PROVIDES LOW THERMAL RESISTANCE SPACE SAVING IN-LINE DESIGN This product has recognition under the component program of Underwriters Laboratories, inc. PRV/LEG 50V 100V 200V 400V 600V 800V Type No. FPIL05 FPIL10 FPIL20 FPIL40 FPIL60 FPIL80 FPIL100 Type No. MPIL05 MPIL10 MPIL20 MPIL40 MPIL60 MPIL80 MPIL100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) 1000V SERIES DESIGNATIONS FPIL MPIL UNITS 40 50 Amp 300 400 Amp 20 35 Amp 10 10 A o Max. DC Reverse Current @ PRV @ 100 C, I R 100 100 A Thermal Resistance (Total Bridge R0- j-c ) 1.2 1.2 o Average Forward Current, I F (Av.) T C = 55 C Max. Peak Surge Current, IFSM (8.3 ms) Max. Instantaneous Forward Voltage Drop, V F =1.2V @ IF = Pulse Test: Pulse Width 300 S. Duty cycle 2.0% Max. DC Reverse Current o @ PRV and 25 C, I R Storage Temperature Range, TSTG -55 to +175 NOTE: O Maximum lead and terminal temperature for soldering, 3/8 inch from case,5 seconds at 250 C. EDI reserves the right to change these specifications at time any without notice. o C/ W o C FPIL Figure 1 Figure 2 CURRENT DERATING NON-REPETITIVE SURGE CURRENT 60 1000 MAX. PEAK SURGE CURRENT IFSM 800 MPIL 50 40 30 FPIL 20 10 0 40 50 60 70 80 90 600 400 MPIL 200 FPIL 100 80 60 40 100 110 120 130 140 150 160 170 180 1 4 2 6 8 10 20 40 60 80 100 NUMBER OF CYCLES AT 60 CPS Tc CASE TEMPERATURE ( C) O NOTE: For large capacitive load derate by up to 20% Figure 3 FPIL and MPIL MECHANICAL OUTLINE Dielectric test voltage 2,500 volts rms, max. 50-60Hz. .193 DIA THRU HOLE 1.125 SQ .405 MAX METAL HEAT SINK _ AC .625 MIN L lF(AV) . AVERAGE FORWARD CURRENT( AMP ) MPIL .20TYP ON CENTERS + .750 MIN .050 DIA.TYP. 1/8 NOM. ALL DIMENSIONS IN INCHES ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:sales@e-edi.com*Wwebsite: http://www.e-edi.com * FAX 914-965-5531 * 1-800-678-0828