T-1 (3mm) BI-LEVEL LED INDICATOR P/N: L-710A8FG/2YD Features YELLOW Description PRE-TRIMMED LEADS FOR PC MOUNTING. The Yellow source color devices are made with I.C. COMPATIBLE. Gallium Arsenide Phosphide on Gallium BLACK CASE ENHANCES CONTRAST RATIO. Phosphide Yellow Light Emitting Diode. WIDE VIEWING ANGLE. HIGH RELIABILITY LIFE MEASURED IN YEARS. UL RATING : 94V-0. HOUSING MATERIAL: TYPE 66 NYLON. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU PAGE: 1 OF 3 Selection Guide Part No. Dice L-710A8FG/2YD Iv (mcd) @ 10mA Lens Type YELLOW (GaAsP/GaP) YELLOW DIFFUSED Viewing Angle Min. Typ. 2 1/2 5 12 40 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Yellow D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR= 5V Absolute Maximum Ratings at TA=25C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA Reverse Voltage 5 V Operating / Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 3 Seconds Lead Solder Temperature [3] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU PAGE: 2 OF 3 Yellow L-710A8FG/2YD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU PAGE: 3 OF 3