SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 PAGE: 1 OF 3
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU
Package Dimensions
Description
The Yellow source color devices are made with
Gallium Arsenide Phosphide on Gallium
Phosphide Yellow Light Emitting Diode.
P/N: L-710A8FG/2YD YELLOW
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where leads emerge from the package.
4. Specifications are subject to change without notice.
T-1 (3mm) BI-LEVEL LED INDICATOR
Features
PRE-TRIMMED LEADS FOR PC MOUNTING.
I.C. COMPATIBLE.
BLACK CASE ENHANCES CONTRAST RATIO.
WIDE VIEWING ANGLE.
HIGH RELIABILITY LIFE MEASURED IN YEARS.
UL RATING : 94V-0.
HOUSING MATERIAL: TYPE 66 NYLON.
RoHS COMPLIANT.
SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 PAGE: 2 OF 3
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU
Selection Guide
Note:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
Electrical / Optical Characteristics at TA=25°C
Absolute Maximum Ratings at TA=25°C
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak Peak Wavelength Yellow 590 nm IF=20mA
λDDominant Wavelength Yellow 588 nm IF=20mA
∆λ1/2 Spectral Line Half-width Yellow 35 nm IF=20mA
C Capacitance Yellow 20 pF VF=0V;f=1MHz
VFForward Voltage Yellow 2.1 2.5 V IF=20mA
IRReverse Current Yellow 10 uA VR= 5V
Parameter Yellow Units
Power dissipation 105 mW
DC Forward Current 30 mA
Peak Forward Current [1] 140 mA
Reverse Voltage 5 V
Operating / Storage Temperature -40°C To +85°C
Lead Solder Temperature [2] 260°C For 3 Seconds
Lead Solder Temperature [3] 260°C For 5 Seconds
Part No. Dice Lens Type Iv (mcd)
@ 10mA
Viewing
Angle
Min. Typ. 2 θ
θ θ
θ 1/2
L-710A8FG/2YD YELLOW (GaAsP/GaP) YELLOW DIFFUSED 5 12 40°
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
SPEC NO: DSAE7198 REV NO: V.4 DATE: NOV/15/2005 PAGE: 3 OF 3
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU
Yellow L-710A8FG/2YD
Remarks:
If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous Intensity / Luminous Flux: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.