Product data sheet Automation technology - sensors and actuators Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL Area Order number M12-A series 713 99 0491 52 12 Illustration Scale drawing Contact arrangement (Plug-in side) You can find the component part drawing and assembly instructions on the next page. Technical data General values Connector design Connector locking system Termination Wire gauge (mm) Wire gauge (AWG) Cable outlet Upper limit temperature Lower limit temperature Customs tariff number Packaging Unit Electrical values male angled connector screw solder 0.25 mm 24 6.0 - 8.0 mm 85 C - 40 C 85369010 100 Cable data Approval 1 Rated current (40 C) Rated voltage Rated impulse voltage Pollution degree Overvoltage category Insulating material group Insulation resistance EMC compliance Degree of protection Mechanical operation 1.5 A (2 A UL) 30 V 500 V 3 II III > 10 not shielded IP67 > 100 Mating cycles Material UL Contact material Contact plating Contact body material Housing material REACH SVHC CuZn (brass) Au (gold) PA PA CAS 7439-92-1 (Lead) CAS 96-45-7 (Imidazolidin-2-thion) Date: 2020-05-06 - Page 1 of 3 Product data sheet Automation technology - sensors and actuators Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL Area Order number M12-A series 713 99 0491 52 12 Component part drawing Assembly instructions / Panel cut-out Date: 2020-05-06 - Page 2 of 3 Powered by TCPDF (www.tcpdf.org) Product data sheet Automation technology - sensors and actuators Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL Area Order number M12-A series 713 99 0491 52 12 Security notices The connectors are designed for use in plant, control system and electrical equipment. The end user is responsible for checking whether the connectors are suitable for use in other applications. Connectors with degree of protection IP 67 and IP 68 are not suitable for use under water. When used outdoors, the connectors must be separately protected against corrosion. For further information about IP degrees of protection refer to `Technical support' in the Download Centre. To lock the cable connector to the equipment connector, the threaded ring is tightened until it is `finger-tight' (approx. 50 cNm). Date: 2020-05-06 - Page 3 of 3